Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Solid Model of Lynch Pin 3

Status
Not open for further replies.

KRISTIEMCK

Mechanical
Joined
Mar 17, 2004
Messages
3
Location
US
Does anyone have a solid model of lynch pins? I can't find any examples on Solidworks web page? Any helpful web pages to find examples?
 
You can try or 3D content central. have you also looked at the SW model library?

Regards,

Scott Baugh, CSWP [borg2]
CSWP.jpg

faq731-376
 
I may have the size you need in our library. My email is danzco@thuston.com
 
EdDanzer
I keep getting e-mails returned that I try to send to you.I only have a few dimensions of the lynch pin that I need. Dia-1/4, Inside ring dia-1 to 1-4. If you have anything close that would be great. I can manipulate it a little after I get it and add it to our library. Thank you so much for your help.
 
KRISTIEMCK,
I think I have a model that will fit your needs. Typing is not my strong suit, so I miss typed my email address. Try ed@danzcoinc.com or danzco@thurston.com , I’m also setting up to do FTP transfers.
 
EdDanzer,
Thank you for all your help!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top