Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Solid Edge v20 Text problem 1

Status
Not open for further replies.

martindelimitev

Mechanical
Joined
Feb 26, 2009
Messages
1
Hi i am using solid edge v 20 and i have a litle problem with text formating. I set the language (bulgarian) in the text properties box chose a font but then when I am trying to write in Bulgarian all i get are some symbols. I use windows Vista 64 . Anyone have clue?
Thanks
 
Which font did you select?

bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
 
Hi,

you must have a font that has the needed characters within
the lower half, that is from 0 to 255. SE can't handle
Unicode chars. These are usually located above code postion
255.

dy
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top