Solid Edge ST3 sketching

[Coolboy55]

It seems to me that sketching in ST3 is more difficult than it was in V20. I liked how in V20 when sketching you could quickly and easily select a sketch plane that was coincident, angled, parallel, perpendicular, etc to something. Is there some way to easily start a sketch in ST3 on a plane parallel to an existing face, some distance from it?

 

[toffeet]

Are you using Ordered or Synchronous?

Regards,
Theodore

Solid Edge ST3 MP1 on WinXP x64

 

[Coolboy55]

I'm using synchronous. I figured out how to get a parallel plane, but how about angled, perpendicular, etc? It was just a couple of clicks in V20, so it must not be as difficult as it seems!

Thanks.