Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Solid Edge ST2 - Gear - bug?
- Thread starter gigon
- Start date
SolidMastermind
Computer
Hi,
No this is not a bug. It has always been the same.
Simply suppress the gear relationship, then rotate the part so that the gears appear to mesh properly. Then un-suppress the relationship.
Best regards
Jon
Jon Sutcliffe / Solid Mastermind
The Solid Edge Community. Video training sessions, best practice documents, process maps and interactive training
No this is not a bug. It has always been the same.
Simply suppress the gear relationship, then rotate the part so that the gears appear to mesh properly. Then un-suppress the relationship.
Best regards
Jon
Jon Sutcliffe / Solid Mastermind
The Solid Edge Community. Video training sessions, best practice documents, process maps and interactive training
- Status
Similar threads
- Locked
- Question