Hi, I am simulating a magnet and solenoid in 2-D planar simulation configuration. I am looking to quantify the magnetic flux captured by the coil wrapped around the core. I am modeling the coil as two halfs on either side of the core. To measure the flux after simulating, I am calculating the line integral at 3 points as shown in the figure, then averaging these values. Is the model and means of quantifying the flux valid? I would prefer planar vs axi.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Solenoid flux measurements
- Thread starter micro7311
- Start date
- Status