kammieorama
Automotive
- Dec 23, 2011
- 31
Dear All,
Is am running an SOL103 and have requested STRESS(PLOT)=ALL.
When i view this in Hyperviews it shows failed to attch result.
A friend said that SOL103 does not support stress output.
My questions are.
1 Does SOL103 not supposrt stress output only but calculates stresses?
(I will use op2 for fatigue analysis)
2. Is there some way to get STRESS in SOL103?
3. Is SOL101 the right SOL for getting calulating modes and stresses?
PS we are colculate modes after applying a RFORCE.
Thank you in advance for your help.
Is am running an SOL103 and have requested STRESS(PLOT)=ALL.
When i view this in Hyperviews it shows failed to attch result.
A friend said that SOL103 does not support stress output.
My questions are.
1 Does SOL103 not supposrt stress output only but calculates stresses?
(I will use op2 for fatigue analysis)
2. Is there some way to get STRESS in SOL103?
3. Is SOL101 the right SOL for getting calulating modes and stresses?
PS we are colculate modes after applying a RFORCE.
Thank you in advance for your help.