D
dmt63
Guest
I have inherited an assembly and I am trying to make it as robust as possible. Need to fix a few things.
We have panels (or is could be a door) that swings 90 degrees. The mechanism is applied correctly to the hinge(s) and all the constraints are from the panel back to the hinge.
We then create a snapshot that shows "DEPLOYED" and "STOWED" positions.
When the snapshot is selected we receive a warning message "720 components from the current snapshot can not be applied."
I have looked over the assembly and nothing is jumping out screaming "fix me" and I am not sure how I can find the components the need to be applied?
Any assistance is appreciated.
We have panels (or is could be a door) that swings 90 degrees. The mechanism is applied correctly to the hinge(s) and all the constraints are from the panel back to the hinge.
We then create a snapshot that shows "DEPLOYED" and "STOWED" positions.
When the snapshot is selected we receive a warning message "720 components from the current snapshot can not be applied."
I have looked over the assembly and nothing is jumping out screaming "fix me" and I am not sure how I can find the components the need to be applied?
Any assistance is appreciated.
