Snap Point defaults - Can they be changed?

[Parisg]

Hi All,

I have been looking to edit the default settings for Snap Points (specifically to de-select "arc center" as default on). Is there an option to do this somewhere?

Thanks

 

[jerry1423]

That's a good question
The only place that I can think of is in the customer defaults
But I will need to check at work tomorrow

 

[JohnRBaker]

There's nothing in Customer Defaults that allows you to affect the Snap Point settings.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[Parisg]

So essentially there is no way to change the defaults?

I recently moved from 7.5 to 9 and don't remember this being an issue previously.

 

[JohnRBaker]

Dialog Memory will take care of changes in at least the current session and perhaps even as a carryover between sessions, but I don't think it covers all situations.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.