Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SMT bend table files

Thread starter Tofflemire
Start date Jan 31, 2007

Status: Not open for further replies.

Jan 31, 2007

Tofflemire

Marine/Ocean

Hi All,

Using Wildfire 3.0

Is there a way to have a SM Part call up 2 different SMT bend table files? This is if I would like to build the same part but with 2 different AWG's.

I was thinking this could be done inside of a family table some how.

Tofflemire