Thanks IRS... been on the yaf... that's where I gleaned the posting... I have XY Plot loaded as a plugin, but, if I try to load the program, the graph areas are blank.
Seems OK to me. I was able to load the plug-in and tweak parameters. However, it seems to be limited to certain, unclearly documented, pre-programmed functions. Nevertheless, for the functions that it can do, it seems to be pretty good and easy to use.
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert!
Can you send me a *.sn file? I cannot even get the one on the site to load properly. What tweaks? According to the limited documentation, the plugin should load vectors... all data types are vectors.
Oh, did you use the Tools | Plugins | X-Y Plot Region to do that? It should have all been automatic; the program downloads the plugin from the SMath wite and installs.
TTFN (ta ta for now)
I can do absolutely anything. I'm an expert!
IRS:
Finally got it working... pretty slick... now to check variable names in plot to see if I can assign a variable to the name... else, I have to pick a scale and scale data.
I uninstalled the program,
Copied all my desktop files to F: drive
Erased all Drive c: with 'SMath'... there was a bunch
Scrubbed the registry of 'SMath'
Reinstalled the program
Installed plugin for XYPlot Region...
and it works... to reiterate, pretty slick. Thanks for the assistance and support.
I had to make sure any remnants were gone... and, I think I scrubbed the system clean. Way back, I 'cleaned' Drive C:, not realising that my files on the desktop were cleaned, too. That's why I copy things to another area.
Not done yet. I tried to isolate the circle and line parts without success. The image shown should work, but, for some reason doesn't. I've attached the actual *.sm file.
Any suggestions? There seems to be a 'disconnect' with the vector name.
