007Driver
Mechanical
- Feb 2, 2005
- 8
Hello,
I am looking for a small hydralic pump and motor. The pump drives the motor by some direct oil lines between the two. The pump must around 3" in diameter and 3" long (a cylider, and the smaller the better). The motor may be 4" or 5" in diameter but only 2" long (a cylider as well, again smaller the better). The pump will rotate at low speeds, roughly 60 RPM to 300 RPM. The motor will run around 1RPM to 10RPM. The power being supplied to the pump will be around .5HP at best (probably around .2HP on average) The motor must deliver a high torque output. It is also needed that the pumps will have the drive shafts exiting both sides of the pumps so they maybe driven/drive from either side. Has anyone worked with or heard of pumps/motors these small with such low operating speeds? I have looked at many sites on the net and asked many suppliers and am still lost. Thanks to anyone who can help.
John
I am looking for a small hydralic pump and motor. The pump drives the motor by some direct oil lines between the two. The pump must around 3" in diameter and 3" long (a cylider, and the smaller the better). The motor may be 4" or 5" in diameter but only 2" long (a cylider as well, again smaller the better). The pump will rotate at low speeds, roughly 60 RPM to 300 RPM. The motor will run around 1RPM to 10RPM. The power being supplied to the pump will be around .5HP at best (probably around .2HP on average) The motor must deliver a high torque output. It is also needed that the pumps will have the drive shafts exiting both sides of the pumps so they maybe driven/drive from either side. Has anyone worked with or heard of pumps/motors these small with such low operating speeds? I have looked at many sites on the net and asked many suppliers and am still lost. Thanks to anyone who can help.
John