Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Slurry Flow Meter 1

Status
Not open for further replies.

TJT

Mining
Joined
Apr 11, 2002
Messages
19
Location
CA
Hi,
I am currently using a doppler style meter to measure the flow of a zinc concentrate/water slurry to an autoclave. The slurry varies between 65% - 75% solids and the average flow is approx. 200 litres/min. We use Toyo style pumps so the flow does pulsate. The pressure is approx.200 psi, and the line size is 3". I am wondering if a different type of meter, mag for instance, would give us a more accurate measurement.

Thanks...Tim
 
Are you trying to get a more accurate instantaneous flow reading (so you can better see the pulsation?) or totalize how much has been transferred over a period of time?

Just a thought, but since I assume you're using a positive displacement type pump, is there any way for you to use the strokes on the pump to get a more accurate reading?
 


200 l/min in a 3" line is pretty low velocity. Sure, magmeters will work even a low velocity as long as the electrode materials are compatible with the slurry and you can always adjust the signal dampening.

The sonic meter shoulh give you good readings, too, but you may be having problems with the flow profile. Slurries take a lot of pipe run before the flow profile stabilizes or becomes fully developed (especiall so at low velocity).

What sort of upstream run do you have? and how "viscous" is the slurry.



 
Since its only 3" a corriolis flow meter could be used. It measures both mass flow and desity.

Check fisher-rosemount.

Best Regards

Morten Andersen
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top