Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Slotted hole detailing dimensions

Status
Not open for further replies.
blackmaddog

blackmaddog

Structural
Joined
Oct 13, 2008
Messages
42
AISC Table J3.3 specifies the standard dimensions of short and long slotted holes. Is the slot length measured out to out or center to center of the radius?

We have one very old reference that shows both options. I don't have a AISC detailing manual to reference.
 
Status
Not open for further replies.

Similar threads

TRAK.Structural
  • Question Question
Residential Addition Detailing
Replies
2
Views
659
TRAK.Structural
TRAK.Structural
Baffled Engineer
  • Locked
  • Question Question
Tension Pile Detailing
Replies
6
Views
7K
HTURKAK
HTURKAK
CollinW
  • Locked
  • Question Question
Concrete Pedestal Reinforcement Detailing
Replies
3
Views
4K
HTURKAK
HTURKAK
Brick Jagger
  • Question Question
AISC 329-09 Detailing for Steel Construction
Replies
6
Views
11K
John Taylor
John Taylor
TRAK.Structural
  • Locked
  • Question Question
Residential Girder Detailing
2
Replies
24
Views
7K
gte447f
gte447f

Part and Inventory Search

Sponsor

Back
Top