Atma khanal
Geotechnical
- Jul 22, 2025
- 1
Hi everyone,
I'm using Slide for slope stability analysis and have noticed that multiple layers of Factor of Safety (FoS) results are generated during each iteration. In one of my models, I observed that the FoS value displayed at the top does not match the critical FoS shown in the detailed output. I also noticed that the font of the topmost FoS value appears different, which raised some concerns.
Has anyone else experienced this issue? Could it be related to overlapping result layers or export settings?
I've attached an output image for reference.
Thanks in advance for any insights!
I'm using Slide for slope stability analysis and have noticed that multiple layers of Factor of Safety (FoS) results are generated during each iteration. In one of my models, I observed that the FoS value displayed at the top does not match the critical FoS shown in the detailed output. I also noticed that the font of the topmost FoS value appears different, which raised some concerns.
Has anyone else experienced this issue? Could it be related to overlapping result layers or export settings?
I've attached an output image for reference.
Thanks in advance for any insights!
