Please I want to know how to change the curves on the TCC graph to just single lines. At the moment they are in block (bands) and it's not giving me the outlook that I like.
Please assist. Thanks.
Please assist. Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
SKM Powertools TCC Curves
- Thread starter PRincez
- Start date
davidbeach
Electrical
I can't open your attachment, but if it's showing what I think it is, given your question, there is no single line representation that would mean anything. Low voltage breakers have a lot of tolerance and you have to assume that the actual trip point is anywhere in that band. If that causes you trouble you have too many things too close together. It can be rather frustrating, but that's life.
EddyWirbelstrom
Electrical
Refer to the CAPTOR reference manual at PTW32\Doc\Reference-CAPTOR.pdf
- Status
Similar threads
- Locked
- Question
- Locked
- Question