Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SKETCH

Status
Not open for further replies.
17566

17566

Aerospace
Joined
May 1, 2006
Messages
14
Location
US
I am using Solid Edge V18, I am working in part file. I have sketch's in the part file, I need to use, is there a way to bring it over to draft file?????

roy
 
Sort by date Sort by votes
Hi Roy,

Yes, Cut and Paste it in. SE will paste it in at the lower left hand corner of the draft sheet, relative to the origin of the sketch in the part file.

From there it can be manipulated like any drawing created in Draft.

Cheers!

Tim
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

josehdx
  • Locked
  • Question Question
projection of points from a sketch to a sketch
Replies
0
Views
283
josehdx
josehdx
lgscobie
  • Locked
  • Helpful tip Helpful tip
Helix wont work in 3d sketch
Replies
7
Views
335
bshand
bshand
WMaleux
  • Locked
  • Question Question
extract sketch out of section view
Replies
1
Views
281
beachcomber
beachcomber
WMaleux
  • Locked
  • Question Question
sketch in part won't turn black
Replies
2
Views
703
WMaleux
WMaleux
asadi2013
  • Locked
  • Question Question
Sketch Circular Pattern
Replies
7
Views
683
Kenny_G
Kenny_G

Part and Inventory Search

Sponsor

Back
Top