Sketch point display size

[icetea73]

Is there any way to alter the display size of sketch points in NX9? Searched preferences and customer defaults but nothing...
They are really too small to work with. Even the constrain symbol sizes seem to be customizable in the defaults so I hope that I'm just missing the setting.
Any help would be appreciated

 

[Arkance/PhoeNX]

Preferences -> Visualisation -> View/Screen (TAB), click on Calibrate and you can slide the sliders up & apply.
However this will increase the size of the WCS and View triads (can't remember the other things it affects).

Anthony Galante
Senior Support Engineer

NX5.0.6, NX6.0.5, NX7.5.5, NX8.0.0 -> NX8.0.3.4
NX8.5.0.23 -> NX8.5.2.3 & NX9.0.0.19

 

[JohnRBaker]

And Cone Heads and Splats (*).

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[icetea73]

Will try that. Thank you.