Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sketch entities flipped

Status
Not open for further replies.

cubalibre000

Mechanical
Joined
Jan 27, 2006
Messages
1,070
Location
IT
Hi,
I've opened a part that before in NX 7 was correct and now has errors.
I've seen that some lines in sketch are flipped. See attached image.
For lines with dimensions I use the alternate solution, but for radius ?
I tried to delete the radius and create again, but all the feature after the sketch need to be reassociated and sometimes is not so simple.

Thank you...

Using NX 8 and TC9.1
 
Hi Cubalibre...

This has been an issue for quite some time now...Best practice is not to add your blends and chamfers in the sketch...
Such features you need to apply on your solid.

Ronald van den Broek
Mechanical Engineer
Cad Environment Coordinator
Wärtsilä, Propulsion Services
NX8.5.2 / TC9.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5

 
I will do this, using external radius+thinkness expression to substituie the radius in the sketch.

Thank you...

Using NX 8 and TC9.1
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top