Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sizing load reactor, based on the VFD or the motor?

Status
Not open for further replies.
Darren000

Darren000

Industrial
Joined
Dec 6, 2012
Messages
5
Please help!
I have a 3HP VFD and a 1/2HP actuator. If I want to add in a load reactor, which one is dominate? the motor or the drive? RM0004M12 or RM0012N25??

Appreciated!!
Best Regards
 
Status
Not open for further replies.

Similar threads

HVAC-Novice
  • Question Question
load assumption (on panel level) for receptacle in bathroom (hair dryer)
Replies
1
Views
9K
resqcapt19
resqcapt19
Gary Featherston
  • Locked
  • Question Question
Standards for Data Centers Master Ground Bar untilizing the P.A.N.I standard
Replies
1
Views
888
DRWeig
DRWeig
rkvbobby123
  • Locked
  • Question Question
Calibration of DC Shunts ranging from 1 mOhms to 10kOhms; Standard these can be calibrated to.
Replies
0
Views
762
rkvbobby123
rkvbobby123
Skythian
  • Locked
  • Question Question
Changes to the definition of arc flash boundary in upcoming NFPA 70E
Replies
5
Views
1K
dpc
dpc
fgtrestk
  • Locked
  • Question Question
Pull Box Sizing over 1000V
Replies
3
Views
1K
resqcapt19
resqcapt19

Part and Inventory Search

Sponsor

Back
Top