Is there any general rule of thumb in torque loop tuning on how to size the load/dyno motor to the tested motor? What if the size of the tested motors vary by orders of magnitude, i.e. 10 to 1000 Nm peak torque? Also, can anyone recommend a good handbook for turque loop tuning? In case its not obvious, I'm just starting out.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
size load motors for torque loop tuning
- Thread starter GmEE
- Start date
Similar threads
- Locked
- Question
- Locked
- Question