Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

sinusoidal

Status
Not open for further replies.
Oliveros

Oliveros

Mechanical
Oct 15, 2003
23

Hello, I need to model a cilinder of 80 mm with an 60 mm concentrical hole, in the top of this, i need to create a sinusoidal wave, I have done a example in AutoCAD, you can see the attached figure, but this is only made with circular fillets, only for illustration proposits. I need a real sinusoidal wave in the top. How can I do this?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Go to Ad$k's Inventor forum and search for "barrel cam" or "cylindrical cam". There are example models posted that should get you started in the right direction.

While the geometry may not be accurate (I'm not sure I'm imagining what you are describing) you will probably find the Emboss feature is what you'll want.
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom