Sinumerik 840d UDE

[aleksandar81]

How can I add Sinumerik 840d UDE in NX to UDE available list, because I don't have it?

NX8.5.

 

[markrief]

The easiest way is to edit your configuration file (probably mach\resource\configuration\cam_general.dat) to point to the ude file that combines the default with the Sinumerik.

Change this line:
USER_DEFINED_EVENTS,${UGII_CAM_USER_DEF_EVENT_DIR}ude.cdl,${UGII_CAM_USER_DEF_EVENT_DIR}ude.tcl

To this:
USER_DEFINED_EVENTS,${UGII_CAM_USER_DEF_EVENT_DIR}Siemens_Cycles_plus_ude.cdl,${UGII_CAM_USER_DEF_EVENT_DIR}ude.tcl



Mark Rief
NX CAM Customer Success
Siemens PLM Software

 

[aleksandar81]

Thank you Mark. The reason I want to use Sinumerik 840D is to change CYCLE832 (_camtolerance , 0,1 ), but after I set tolerances in Sinumerik 840 UDE it stays the same.