aleksandar81
Mechanical
How can I add Sinumerik 840d UDE in NX to UDE available list, because I don't have it?
NX8.5.
NX8.5.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Sinumerik 840d UDE
- Thread starter aleksandar81
- Start date
- Status
The easiest way is to edit your configuration file (probably mach\resource\configuration\cam_general.dat) to point to the ude file that combines the default with the Sinumerik.
Change this line:
USER_DEFINED_EVENTS,${UGII_CAM_USER_DEF_EVENT_DIR}ude.cdl,${UGII_CAM_USER_DEF_EVENT_DIR}ude.tcl
To this:
USER_DEFINED_EVENTS,${UGII_CAM_USER_DEF_EVENT_DIR}Siemens_Cycles_plus_ude.cdl,${UGII_CAM_USER_DEF_EVENT_DIR}ude.tcl
Mark Rief
NX CAM Customer Success
Siemens PLM Software
Change this line:
USER_DEFINED_EVENTS,${UGII_CAM_USER_DEF_EVENT_DIR}ude.cdl,${UGII_CAM_USER_DEF_EVENT_DIR}ude.tcl
To this:
USER_DEFINED_EVENTS,${UGII_CAM_USER_DEF_EVENT_DIR}Siemens_Cycles_plus_ude.cdl,${UGII_CAM_USER_DEF_EVENT_DIR}ude.tcl
Mark Rief
NX CAM Customer Success
Siemens PLM Software
- Thread starter
- #3
aleksandar81
Mechanical
Thank you Mark. The reason I want to use Sinumerik 840D is to change CYCLE832 (_camtolerance , 0,1 ), but after I set tolerances in Sinumerik 840 UDE it stays the same.
- Status