I want to use a 2N2222 transistor to switch on and of Christmas light using a microcontroller. The collector and emitter of the transistor is in series with the Christmas lights wire. The base of the transistor is connected to a 5 Volt output of a microcontroller. My question is do I need a common ground? If so where would be the best place for it? I tried to hook up the circuit but nothing happens. Help!!!
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Simple Switch 3
- Thread starter wpayton
- Start date
-
1
- #2
You should tried to place a resistor on the emitter of your transistor and your output will be between the emitter and the resistor. I will tried to have a common ground between the micro controller and the christmas light circuits. I am still a students but give it a shot...hope it will help.
-
2
- #3
A good circuit would be a transistor that drives a relay. Then the relay contacts can be placed in series with the Christmas lights. Connect the output of the microcontroller with the base of the transistor through a 1-5k ohm resistor, ground the emmiter and place the relay coil between the colector of the transistor and the 5 volts power supply. Don't forget to place a diode (1N4001 or 1N4148) across the relay coil to protect the transistor from back EMF. <br>
GOod luck !
GOod luck !
ronhotchkiss
Mechanical
The relay suggested is a good idea. Remember you are controlling AC with the output of your transistor. To get around the idea of a common ground, use an opto isolator or simply power the mechanical relay with the microcontroller output. Either of these methods will eliminate the need for a common ground and might save your microcontoller, too!
- Status
Similar threads
- Locked
- Question