Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Simple (hopefully) question about Isometric Views in Drafting

Status
Not open for further replies.
tdp240

tdp240

Mechanical
Nov 1, 2005
49
When I create an isometric view in drafting, the coordinate system does not appear, yet I see it in drawings that others create. How do I get the coordinate system to appear next to my part in an isometric view?

WinXP-SP3 / NX5.0.4.1 MP6 / Catia V5r18 / NX I-deas 5.3.0.14
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Ciao!
Try Tools - Options - Drafting - Layout - View Creation - check "View axis system based on 3D axis system".

Not sure if this works because my "company" locked all CATSettings :-(

P.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

J
  • Question
CatiaV5R29 - Drafting standards question
Replies
0
Views
762
javier_mat
J
A
  • Question
CATIA v5 DRAFTING
Replies
5
Views
7K
amadali
A
sri91
  • Locked
  • Question
lock views password
Replies
2
Views
382
sri91
sri91
Y
  • Locked
  • Question
About copy - paste special - copy with link in product 1
Replies
3
Views
2K
yamaCad
Y
A
  • Question
CATIA V5 DRAFTING/DRAWING TITLE BLOCK SCALE UPDATE 1
Replies
5
Views
4K
amadali
A

Part and Inventory Search

Sponsor

Back
Top Bottom