Konstruktor
Mechanical
This should be easy and not questioned here, but... How in IV(11) simple (extruded) cut can be done so, that both sides are keeped? Or you can't do this?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Simple cut?!
- Thread starter Konstruktor
- Start date
- Status
aardvarkdw
Mechanical
Both sides are kept? What do you mean? What are you trying to accomplish?
- Thread starter
- #3
Konstruktor
Mechanical
First I would use this possibility to create multibodys - like I did with SolidWorks 
. Another reason to use it is, for example, instead of using corner rip. (When I suddenly need a flat pattern from sheet metal box with closed corners...)
. Another reason to use it is, for example, instead of using corner rip. (When I suddenly need a flat pattern from sheet metal box with closed corners...)- Status