Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SimDesigner Fatigue

Status
Not open for further replies.
PhV

PhV

Computer
Joined
Jun 2, 2004
Messages
11
I'm just opening this discussion cause we are about to migrate in CATIA V5 and lots of discussions are around Nastran integration too. Any ideas on SimDesigner state of the art now ?

I'm a bit suspicious about integration into CATIA V5 and i might be wrong, but so far there is no emerging simulation products on top of it... i might be wrong again...

Any hints or advices appreciated

Ph.V
 
Status
Not open for further replies.

Similar threads

thecadguy
  • Locked
  • Question Question
Linear vs Non-Linear Stress for Fatigue
Replies
0
Views
150
thecadguy
thecadguy
srikanth1983
  • Locked
  • Question Question
high cycle fatigue in NX
Replies
0
Views
96
srikanth1983
srikanth1983
luisad
  • Locked
  • Question Question
Fatigue analysis Nastran
Replies
2
Views
172
hezhj2000
hezhj2000
vijuoo7
  • Locked
  • Question Question
nastran embeded fatigue
Replies
1
Views
134
hezhj2000
hezhj2000
vijuoo7
  • Locked
  • Question Question
fatigue analysis
Replies
4
Views
294
hezhj2000
hezhj2000

Part and Inventory Search

Sponsor

Back
Top