I would like to make a slab out of silver oxide powder with the silver applied to a mesh. I was thinking of a cold two stage rolling operation using paper on each side as a web. I am thinking I may need a binder mixed with the silver or sprayed onto the grid. Does anyone have any input on this idea?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Silver Oxide powder rolling to produce a slab
- Thread starter energised
- Start date
MikeHalloran
Mechanical
If the mesh is made of, or plated with, something that will bond to silver oxide with just pressure, maybe you have a chance.
I'd be inclined to try sintering the powder to silver- plated screen cloth, with secondary rolling/ calendering only if you need it to flatten out the slabs.
Mike Halloran
NOT speaking for
DeAngelo Marine Exhaust Inc.
Ft. Lauderdale, FL, USA
I'd be inclined to try sintering the powder to silver- plated screen cloth, with secondary rolling/ calendering only if you need it to flatten out the slabs.
Mike Halloran
NOT speaking for
DeAngelo Marine Exhaust Inc.
Ft. Lauderdale, FL, USA
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question