signal builder block

[agein]

hi

i have a pulse which switches on and off at a certain frequency and i have a custom signal in the signal builder block whicj I want to trigger by using the pulse. is there any method by which I can do that.

 

[brokensoul]

agein,

Try a switch..

I am guessing that the pulse is 0 or 1 so you can have the switch pass 0, input 1, unless threshold, input 2, = 1 then pass signal generator output, input 3.


inputs are labeled 1 to 3 from top to bottom on the block... else you can open itand read the help info in it.

hope this helps
BSK