All
i have been searching but didnt find the sollution so far. My design is a bit dfferent but you could explain it in the next example i think i can use it also for my assembly
so lets say we have a wing tip and want to do a flow analyses we desing the wing tip and the fluid domain substract one from the other and do the simulation.
When getting the results i want to see the wingtip again instead of the 'hole" . how can i do that?
wich step did i miss
kind regards
ps if i have to do something else for an assembly please let me know
i have been searching but didnt find the sollution so far. My design is a bit dfferent but you could explain it in the next example i think i can use it also for my assembly
so lets say we have a wing tip and want to do a flow analyses we desing the wing tip and the fluid domain substract one from the other and do the simulation.
When getting the results i want to see the wingtip again instead of the 'hole" . how can i do that?
wich step did i miss
kind regards
ps if i have to do something else for an assembly please let me know
