Siemens NX NX8.5

[jackmarbles]

I am thinking about loading this version. Is it stable?

I asked my rep Doug Gudorf, he said it was ok to load and use. Any opinions of NX8.5.
jack

 

[PSI-CAD]

Hi Jack

I use NX8.5 since October and it's OK for me


Regards
Didier Psaltopoulos

http://www.psi-cad.com

 

[RUGmechanic]

I downloaded NX8.5 as soon as it came available on the gtac site.
Stable on hp xw8600 winXP 32bit ever since.
Large assemblies need to be taken care of as usual...But that is more hardware related.

Older budweiser

 

[uwam2ie]

8.5 works as stable as the last 8.03mp2
even some problems did not occur in 8.5

 

[Tingsryd]

Since maintenance release 1 will be released soon, IMO you could start your migration but wait on using it in production until after you have installed MR1. There are always many tweaks in the first MR. Also, you might consider leaving 8 installed for a while; just in case.

NX8