Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Side View Dimensioning of Interupted Feature of Size/Chamfers/etc

Status
Not open for further replies.

njm789

Automotive
Joined
Oct 9, 2019
Messages
25
Location
US
Hi all,

What is the correct way of dimensioning a feature of size that is interrupted such as the height of the part below or chamfers/radii from a side view that are continuous. Eg. Would it be 4X CHAMFER or 8X CHAMFER (is it confusing/wrong to put 8X if only 4X are visible in view)/similarly would the height be DIM, 2X DIM, or 4X DIM?

3D_cytrwq.jpg


dim_cp34b9.jpg
 
They are considered separate features so yes, 8X. Also, the 102.5 dimension should be 4X.

"Know the rules well, so you can break them effectively."
-Dalai Lama XIV
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top