Can anyone give me some advice in designing one? Right now, my design is a simple lever arm. It has a pivot point and counter weight. It also has a wheel to allow the arm to rotate. The arm is a circular pipe inside another circular pipe, this allow for translation and rotation. Any feedback on this matter would be very helpful.
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Shroud manipulator for continuous casting
- Thread starter haydenle
- Start date
Similar threads
- Locked
- Question