Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Showing Threads 1

Status
Not open for further replies.
KimBellingrath

KimBellingrath

Mechanical
Joined
May 14, 2003
Messages
103
Location
US
What is the current standard in regards to showing threads on a drawing? I used to show them in a front view or in a section but not when hidden and now I am told that they don't have to be shown at all.

What does ANSI require?
 
Sort by date Sort by votes
I've always been told to show them when visible (front view for screws, section for holes and screws...)

Cyril Guichard
Mechanical Engineer
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

metootoo
  • Locked
  • Question Question
Conflicting info about ACME threads
Replies
1
Views
243
metootoo
metootoo
QAFitz
  • Locked
  • Question Question
B1.16M Screw Threads
Replies
0
Views
150
QAFitz
QAFitz
kross68
  • Locked
  • Question Question
internal threads
Replies
4
Views
335
chicopee
chicopee
Rich1969
  • Locked
  • Question Question
Threads
Replies
1
Views
226
PSE
PSE
MechCT
  • Locked
  • Question Question
Screw Threads
Replies
4
Views
255
MechCT
MechCT

Part and Inventory Search

Sponsor

Back
Top