Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Show param. part number or model_name instead of number

  • Thread starter Thread starter texaspete
  • Start date Start date
Status
Not open for further replies.
T

texaspete

Guest
Greeting, This is what I want to do. Using Pro/report, a exploded view, First Proe places a number in a balloon when I auto balloon. I want proe to put the &model_name. The reason is this, I have to manual create BOM (no pro/report) and have to manual put in part numbers (or in my case model_name)s.

My tech support said that I have to create a symbol but I don't know what to place in the symbol to make the custom balloon find or get the model_name. Does anyone have a solution.

Thanks in Advances. Texaspete.
 
I take that you know how to create an Alt Symbol.



When you redefine the symbol, put '&model_name' in place of '\index\'
 
I am sorry to say that I do not know how to create an alt symbol. The message I get is this Symbols for BOM balloons must have variable texts. I don't know what to must in the symbol. Should I type /model_name/ or /&model_name/ ?

Thanks for your first reply. Can you help. Texaspete.
 
I think 'Alt Symbol' requires to have '\qty\'.



What I did was, created a symbol that looks like a bom balloon with quantity.

Then on top half of balloon, I put the note&model_name and on bottom \qty\



Make sure there is no backslash on top just &model_name and with backslash on bottom \qty\
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top