Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Show center of gravity on idw (Inventor 11)
- Thread starter rossen
- Start date
I realize it's been some time since this post but here is the only way I found to work around this.
Move the part so the origin is at the center of gravity. Then place a feature of a sphere of very small dimension (sphere won't change COG) at the origin. You will be able to dimension to the sphere unless it is totally imbedded within the part.
Move the part so the origin is at the center of gravity. Then place a feature of a sphere of very small dimension (sphere won't change COG) at the origin. You will be able to dimension to the sphere unless it is totally imbedded within the part.
Try this add-in:
There may be other ones out there as well.
There may be other ones out there as well.
- Status
Similar threads
- Locked
- Question