Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Show a tolerance zone

  • Thread starter Thread starter Tesla77
  • Start date Start date
T

Tesla77

Guest
How do you show a tolerance zone on a drawing? As in a GD&T profile tolerance.
 
Assuming you got to the geometric tolerance box....
under the symbol tab, select unilateral
when you go to place the symbol, it will ask which side you desire the tolerance to apply.
select ok.
 

Part and Inventory Search

Sponsor

Back
Top