Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Short Concrete Cantilever 1

Thread starter pbw
Start date Jul 3, 2001

Status: Not open for further replies.

Jul 3, 2001

pbw

Structural

I've got a short concrete cantilever 3" lg. x 1' deep. The cantilever is from a slab on grade that will extend over a conveyor pit and support a traffic plate. What is the appropriate way to check the cantilever? Should I check shear from a shear friction standpoint (corbel) Vu=Av*Fy*u? or should I check it as beam shear Vc=2*(f'c)^.5*bw*d? Can I incorporate both for capacity?

Also what are your thoughts on the width of the "beam section (bw)", I am considering a 2' beam width since the traffic plate is 2'wide.

Thanks
PBW