Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
shell to solid submodel
- Thread starter SKJoe
- Start date
Read the help file. It shows:
/PREP7! The .CBDO file must be read in PREP7
/INPUT,,cbdo ! Reads Jobname.cbdo up to the /EOF command
/INPUT,,cbdo,,:cb1 ! Reads same file from the label :cb1
It is read twice because there is an end of file (/eof) command in the cbdo file, which you must then bypass by reading in a second time (after the given label :cb1 -- see above).
------------
See faq569-1083 for details on how to make best use of Eng-Tips.com
/PREP7! The .CBDO file must be read in PREP7
/INPUT,,cbdo ! Reads Jobname.cbdo up to the /EOF command
/INPUT,,cbdo,,:cb1 ! Reads same file from the label :cb1
It is read twice because there is an end of file (/eof) command in the cbdo file, which you must then bypass by reading in a second time (after the given label :cb1 -- see above).
------------
See faq569-1083 for details on how to make best use of Eng-Tips.com
- Status
Similar threads
- Locked
- Question