Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Shell Slots

Status
Not open for further replies.
femorotti

femorotti

Mechanical
Joined
Jun 15, 2008
Messages
5
Location
NG
Please can anyone tell me how to design/ specify slots for a Tank shell of 64m OD 12m high of 200,000 barrels.

The tank is being refurbished causing it to have a double bottom.

Look forward to receiving tips that can help.
 
Sort by date Sort by votes
Are the slots for the second bottom down low or for circulation vents up high?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Kathia Buena
  • Locked
  • Question Question
5.7.8 Flush-type Shell Connections
Replies
2
Views
550
Kathia Buena
Kathia Buena
Youcef40
  • Locked
  • Question Question
Using thickened sheet plates to patches shell plates courses.
Replies
7
Views
776
Dhurjati Sen
Dhurjati Sen
Youcef40
  • Locked
  • Question Question
Can we use the plate A283 Gr C instead of the S 275 Jr in storage tank shell repair?
Replies
8
Views
1K
Youcef40
Youcef40
Muza33
  • Locked
  • Question Question
PWHT requirement of shell plate buttweld for API 650 tanks if simulated PWHT required for plates
Replies
6
Views
1K
IFRs
IFRs
Frank Zhang
  • Locked
  • Question Question
API 650 5.1.5.7 Shell-to-Bottom Fillet Welds, annular plate more than 13does code allow fillet only
Replies
7
Views
1K
IFRs
IFRs

Part and Inventory Search

Sponsor

Back
Top