E
edvermaak
Guest
When ripping a shelled solid part converted into sheet metal in a typical sheet metal box design, a "V" corner cutout relief is created, and by default (unless specified differently using the relief options), the inner edges of the walls of box flanges meet.
When adding a wall to a converted (or even a newly created sheetmetal past for that matter), I'd like to have consistency in design by ensuring that all the inner walls meet and a "V rip" is created, as created in the solid to sheet metal conversion. How do I do this?
Ed
When adding a wall to a converted (or even a newly created sheetmetal past for that matter), I'd like to have consistency in design by ensuring that all the inner walls meet and a "V rip" is created, as created in the solid to sheet metal conversion. How do I do this?
Ed
