Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sheetmetal Doubt

  • Thread starter Thread starter QSQCaito
  • Start date Start date
Status
Not open for further replies.
Q

QSQCaito

Guest
Hello guys, wonderful forum. That's why I'm posting again, need some help with shheetmetal.

4shared.com - photo sharing - download image error chapa.jpg ml?dirPwdVerified=611c6210

I want to put sheetmetal in 3 parts. One where you can see it in the picture, where I created a plane, and in between in the upper part. I can put sheetmetal in any of the 3, but then anywhere else. An error appears, translated it would be something like "the plane of the sketch for the flap must match up with the superior or inferior part of the base of the solid"

I really don't understand what this means, nor what solid is he talking about. I'll leave you the solid file in case you want to see it in your language.




Thanks a lot in advance!

PS: slwrks file
4shared.com - online file sharing and storage - download (2) Chasis Cobra FORUM.SLDPRT ra_FORUM.html?dirPwdVerified=611c6210
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top