Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
SHEET PILING"JACKING"vsDRILLED SHAFT "SECANT"PILING
- Thread starter JROCK
- Start date
JROCK, what kind of info about VE are you looking for? In the final analysis it's a comparison of total project cost. Fuzzy parameters like time to install or public inconvenience during construction might apply. Life cycle cost, maintenance or aethestics might not apply depending on the project. Perhaps a difference between sheet pile and secant pile might be that your sheet pile wall would only be temporary shoring and a reinforced concrete structural lining would have to be built inside whereas you could design a secant pile wall to be both shoring and final structural lining. That would depend on what you're building.
JROCK - we have substantial experience in value engineering using "jacked" or "pressed in" sheet piles.
However to point you in the right direction, we would need to get more information on the specific project.
Obviously if you are looking at these two options there are vibration issues, however how close to structures will the piling line be? What is the purpose of the wall? How water tight does it have to be? How much access or right-of-way is given? Is it permanent or temporary? Also, beyond just soils, where is the water table? Are there contaminates to worry about? Is there a time factor involved?
Sorry, but these questions are relevent to adequately access the potential savings.
If you want more information you can contact the company we deal with directly through their website at:
However to point you in the right direction, we would need to get more information on the specific project.
Obviously if you are looking at these two options there are vibration issues, however how close to structures will the piling line be? What is the purpose of the wall? How water tight does it have to be? How much access or right-of-way is given? Is it permanent or temporary? Also, beyond just soils, where is the water table? Are there contaminates to worry about? Is there a time factor involved?
Sorry, but these questions are relevent to adequately access the potential savings.
If you want more information you can contact the company we deal with directly through their website at:
- Status
Similar threads
- Locked
- Question
- Locked
- Question