Hello everybody,
I have the following problem: in sheet metal catia V5 I have to create a part which is symmetric; I created one half but I have problems when I want to create the other half.How should I proceed? I made the symmetry for the sketchers and then I created the walls but the model size became too large.
Is there any way to duplicate just one half symmetrically and to do then the bend between 'em?
Thank you in advance.
I have the following problem: in sheet metal catia V5 I have to create a part which is symmetric; I created one half but I have problems when I want to create the other half.How should I proceed? I made the symmetry for the sketchers and then I created the walls but the model size became too large.
Is there any way to duplicate just one half symmetrically and to do then the bend between 'em?
Thank you in advance.