is there any way to do a 360 degree fold on sheet metal without the rigamaro of doing two 90s, etc. i'm trying to create cylindrical shapes for industrial nozzles (duct) etc. am i missing some neat inventor functionality for creating cylindrical ducting that i can then create flat patterns for?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
sheet metal folds
- Thread starter nitrocad
- Start date
- Status
Similar threads
