Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Sheet Metal Draft

Status
Not open for further replies.

IngEfren

Industrial
Joined
Dec 5, 2008
Messages
1
Location
MX
I'm working in SolidEdge ST, but in traditional mode for sheet metal. I created some parts, but for making draft...How do I mark the lines for then bends on the flatten view.

ANd when we are doing that, can we make it dotted line??

Thanks!!!

Hope you can help me

Ing. Efren Ramirez
 
see this thread
thread562-231085

bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top