Sharp Corner Angle in Steel

[aepeszel]

Hello
I have heard that some steel is available in a sharp corner design. Does anyone know where to find any? I am looking for a piece of angle 1/4 thick. We thought of formed plate but it would give a radius that is too big.
Thank you

 

[metengr]

It sounds like you might need to procure an extruded piece. I would check the internet and look for steel suppliers that can provide special order extruded shapes.

 

[aepeszel]

metengr
That is what I thought as well. I have looked briefly but did not have the time to look earlier. I will try again to search the net.
aepeszel

 

[TVP]

I would recommend discussing your application with Plymouth Tube. They are a leader in steel extrusions. Use the following link for more information:

http://www.plymouth.com/products/Se...ddGrade=none&SizeType=inches&btnSearch=Search