Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Shaker parts

Status
Not open for further replies.

floattuber

Mechanical
Jan 22, 2006
126
Anybody use vendors other than the OEM shaker companies to get little generic parts for your shakers? UD wants an arm and a leg for everything, plus they have a $75 handling fee for every order. Specifically, I'm looking for the rubber diaphragm used to keep debris out of the armature.
 
Replies continue below

Recommended for you

We have used sheet neoprene for years on our MB C-150. Lasts quite well. Seal with RTV. (Ours is oil & water cooled)

Shaker Service Company in CT:
Ling/ACG (acgdynamics.com) Service all types of shakers.
Been around for years.
Can't say they're cheap, but never hurts to check.

Scott
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor