Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

shaft torsion

  • Thread starter Thread starter -
  • Start date Start date
Status
Not open for further replies.

Guest
can anyone give me a practical example (an exercise) how to model a shaft subjected to torsion using axysimmetric formulation with any FEM code? I use COSMOS/M code but it isn't important, I would learn the general concept.
I'm sorry for my bad english but I'm italian so....

Thanks
 
Status
Not open for further replies.

Similar threads

moiz19670309
  • Question Question
Hole size with tolerance for Shaft
Replies
7
Views
8K
Gr8blu
Gr8blu
Flying Whale
  • Question Question
Movable-shaft design for adjustable gear teeth engagement
2
Replies
21
Views
6K
mfgenggear
mfgenggear
AlphaH2Omega
  • Locked
  • Question Question
Torsion shaft special required please
Replies
18
Views
872
AlphaH2Omega
AlphaH2Omega
amarks
  • Locked
  • Question Question
Sizing Shaft Diameter
Replies
14
Views
1K
drawoh
drawoh
buzzedge
  • Locked
  • Question Question
Using oring to maintain small shaft vertical position
Replies
15
Views
7K
TugboatEng
TugboatEng

Part and Inventory Search

Sponsor

Back
Top