Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
SHAFT TIR
- Thread starter mcguirepm
- Start date
I don't have the numbers but there are standards put out by AISI/SAE and probably others, but your tolerances are set by what your bar producer can achieve.
Anytime you request a tightening of a tolerance for any of the measured parameters you will generate an adder to your price. We used several suppliers for TG&P/TG bar based on their capabilities.
Anytime you request a tightening of a tolerance for any of the measured parameters you will generate an adder to your price. We used several suppliers for TG&P/TG bar based on their capabilities.
- Status
Similar threads
- Locked
- Question
- Locked
- Question